Pairing the card reader with iPad

Setting up the terminal involves:

  1. Pairing the card reader with your iPad
  2. Connecting the card reader to your AirREGI App

In this page, you'll learn how to pair the card reader to your iPad.

How to pair the card reader with iPad

Turn on the card reader.
Press the small button on the right top corner of the card reader or the green check mark key until the Bluetooth symbol appears on the display and the flashing blue light speeds up on the top right of the card reader. Now the card reader is searching for a device to pair with.

Open your iPad settings and select a "Bluetooth" and turn it on.

In the Bluetooth settings of your iPad, select "Miura" to begin the pairing process.

Note

The three-digit number that appears after "Miura" is the last 3 digits of your card reader's serial number on the back of the device.

When the “Bluetooth Pairing Request” message pops up on your iPad, press the green check mark key on your card reader, then select "Pair" on the iPad.

Your iPad will show the card reader is connected.

Once it's all done, proceed to connect the card reader to App.

Note

To pair your reader again, select Settings then Bluetooth on your device. In the list of Bluetooth paired devices, select Miura and "Forget this device". On the Miura, hold down the green tick for 5 seconds. Repeat the pairing process as above.
In order to use card reader consistantly, please make sure to always charge the card reader with the card reader stand or the attached USB connector.